What Dies do I Need for My DK93 KAM Snaps Table Press

 

  The DK93 KAM table press has holes to accept the following die shanks:

• Top die shank: approx 8mm (5/16") diameter (screws in - M8 threading)
• Bottom die shank: approx 19mm (3/4") diameter 

If you have this press, or one with the same hole sizes, you will first need the DK93-KX adapter base in order for the majority of our dies to fit the press. (Only 1 adapter is needed per press.)

Then, click on the specific fastener from the list in the master buying guide for the direct links to the dies needed.