Removal dies will also fit KX-T2 and DK93 presses but centering the rivets may be more difficult so dies may not work as well. Use at your own discretion.
The same removal dies can remove both our 8mm and 9mm double cap rivets.
Some users have reported success with our 10mm rivets but others have reported difficulty. Rivet may need to be punched through on one side, then flipped over and punched through from the other side. Use at your own discretion.
Note: Dies were tested with the rivets we sell. Results may vary with rivets from other sources.
We recommend you practice on scrap several times first to avoid damage to your project.
Removal dies will cut into the rivets, resulting in sharp edges which may snag. Needle-nose pliers (not included) can be used to help dislodge snagged rivets. Refer to video.