How to Make DK93 Dies Fit Your DK98 KAM Press

October 21, 2026

DK93

DK98

 


The DK93 and DK98 KAM presses fit dies with different shanks.  

DK93 dies:

  • Top die shank: approx 8mm (5/16") diameter (screws in - M8 threading)
  • Bottom die shank: approx 19mm (3/4") diameter

DK98 dies:

  • Top die shank: approx 9mm (3/8") diameter (requires allen wrench)
  • Bottom die shank: approx 12mm (1/2") diameter

If you have a DK98 press (with the rounded handle) but dies that fit the DK93 press (straight handle), those dies will not fit directly in the DK98 press.  Instead, you will need to "convert" the holes in the DK98 press to accommodate the shanks of the DK93 dies.

KAMsnaps offers adapters that will make this work. You will need both of the following:

  • DK98-DK93 adapter. This will replace the existing black base that is inserted in the DK98 press to create an opening that will fit 3/4" (19mm) bottom dies. Instructions for replacing the black base can be found here.

  • DK98-KX adapter.  This is a 2-piece set**.  The top piece will "convert" the top hole of the DK98 so that it will accept M8 (8mm) screw-in dies.

** The bottom piece of the DK98-KX adapter can be used in the original DK98 black base so that the press will accept our bottom KX dies, which have 9.9mm (approx) shanks. Alternatively, if you don't want to keep switching out the black bases, you can purchase the DK93-KX adapter to fit the replacement black base.


Back to the top