Will KAM Dies Fit my Press?

August 07, 2018 1 Comment

There are many presses out there that are made to look similar to our DK93 KAM press model.  But if they don't say KAM on them, then they are *not* KAM.

Generally speaking, our KAM dies are molded to fit our KAM presses.  Below are the dimensions of our 3 models of dies, so you can compare them to your existing press to see if they might fit.  Compatibility is not guaranteed if our dies are used with presses or fasteners not sold on our site.  Please review our return policy.

If your press has an attached screw on the bottom, as shown below, it is *not* compatible with any top or bottom dies sold at KAMsnaps.com.

Not compatible with KAM snaps

 

Dimensions are approximate.

DK93:
Bottom die shank: approx 3/4" diameter 
Top die shank: approx 5/16" diameter (screws in)

DK98:
Bottom die shank: approx 1/2" diameter
Top die shank: approx 3/8" diameter (requires allen wrench)

KX:
Bottom die shank: approx 3/8" diameter
Top die shank: approx 5/16" diameter (screws in)

 

If our DK93 dies are compatible with your machine, you can use:

 

If our DK98 dies are compatible with your machine, you can use:

 

If our KX dies are compatible with your machine, you can use:

 

Most of our dies are available in the KX series so that they can be used between all 3 different machines.  If you're still confused, contact us for assistance.

 

KAMsnaps Press Die Attachments


1 Response

Chris Weston
Chris Weston

September 04, 2019

Thanks so much Judy. Will do some measuring.

Leave a comment

Comments will be approved before showing up.

Back to the top