Punches out a small hole, approx 1.5mm wide, for snaps and rivets. For most materials, these will cut out an actual hole. Unlike our " hole cutting dies," these "hole punch dies" utilize a pointed tip rather than a bladed circle to make the hole.
Note: As a result of a storage leak, dies have minor surface rusting which does not affect function. Rust can be wiped off with vinegar. See last thumbnail photo. Sales are final.
Disclosures: Dies are industrial equipment and may have scratches, rust, oil or other cosmetic imperfections that will not hinder their function. Returns or exchanges cannot be accepted unless a defect affects function.
I purchased this thinking I was going to use it on some leather, but I guess the leather was too thick. It sort of dented the leather, and there was no way you could get a rivet stem through that very tiny hole. So buyer just be aware. However, it worked well for thinner fabrics, paper, etc., and rivets went through those fine.
S
Sherrye J
1.5 punch
This is great for marking areas without leaving a large hole. Just in case your a smidgen off it's not going to impede the hole punching. I really like this. Now to find a 2.0 punch and I'm set.