KX Dies for Cover Buttons

• size 20 (1/2")
• size 24 (5/8")
• size 30 (3/4")
• size 36 (7/8")
• size 45 (1 3/32")
• size 60 (1 1/2")
  
  

• Cover buttons are lightweight and intended for use with lightweight fabric such as a single layer of cotton (*not* upholstery, vinyl, leather, thick fabric, etc)
  
• You may want to add a dab of glue under the wire back as a precaution to ensure a permanent hold.
  
• Covered buttons should *not* be machine washed or dried, as the agitation may cause them to separate.
• Some die sizes have a snugger fit around the cover button than others and may require that you insert the tip of scissors (or similar) through the wire loop to pull out the button from the die.
• I tested with a layer of t-shirt material, then a layer of felt.  Both worked fine, but the felt, being thicker, was a little more difficult to remove from the die. I definitely recommend a thinner material but just so you know, the felt was doable.

• KX8J pro-handheld
• KX-T2 pro-standup press
• DK93 table press with DK93-KX adapter base
• DK98 table press with DK98-KX adapter set
• Important! Table presses require the adapters listed above in order to fit the KX dies.
• Not compatible with K1/K2 basic pliers for plastic snaps
  
  

​Optional: Leave a note in the Order Notes box at checkout requesting that your order be reviewed for completeness. We'll contact you if anything appears to be missing or if your tools aren't compatible with your fasteners.